Frequency changed alarm was incorrectly disabled
Transformer Ratio alarm was not working
Invalid tap numbers are now ignored (instead of clamped), it uses last valid value
Average Error for Ext Loop Max Error % is now squared and sqrt’d to avoid sign problems
Dynamic NCC algorithm changed to account for Top and AutoLower logic
New External Loop Disabled alarm (reports when ExtLoop is disabled for 60s)
Balance uses same permissives as External Loop
Substation tap changer end of life message was incorrectly generated
Charge 1 reports AvgMW equal to ChargeMW
For Z and R only regulation modes, I-Z/R Max Error % is used (Willie)
R regulator clamps SP to >R_sc
Fixed AdvancedControl configuration, it did not save changes properly
ShadowMode bit is logged